How to Set Up Your Skateboard: A Step-by-Step Guide

How to Set Up Your Skateboard: A Step-by-Step Guide

Introduction
Setting up a skateboard is a fundamental skill that every skater should master. Not only does it allow you to customize your ride to your preferences, but it also ensures that you understand your board's components and how they contribute to your skateboarding experience. This step-by-step guide will walk you through the process of setting up your skateboard, from assembling the deck to fine-tuning your trucks.

Step 1: Gather Your Components
Before you start, ensure you have all the necessary components:
  • Skateboard deck
  • Two trucks
  • Four wheels
  • Eight bearings (two for each wheel)
  • Skateboard hardware (screws and bolts)
  • Griptape

Step 2: Apply Griptape to the Deck
  1. Positioning: Lay your griptape sheet over the deck to align it properly.

  2. Application: Peel off the backing and carefully stick the griptape onto the deck, starting from one end and smoothing it out to avoid air bubbles.

  3. Trimming: Use a sharp blade to trim the excess griptape around the edges of the deck.

  4. Finishing: Create a rough edge by running the blade along the border of the deck. Sand the edges for a smooth finish.

Step 3: Attach the Trucks
  1. Poke Holes: Use a screwdriver to poke through the griptape at the truck mounting holes.

  2. Position Trucks: Align the trucks with the holes, ensuring the kingpins face inward towards each other.

  3. Secure Hardware: Insert the screws from the top of the deck and tighten the nuts from below. Ensure they're snug but not overly tight.

Step 4: Install Bearings and Wheels
  1. Insert Bearings: Place a bearing on the truck axle, then press a wheel onto it to seat the bearing. Flip the wheel and repeat for the other side. Use a bearing spacer if available.

  2. Attach Wheels: Slide the wheels onto the axles, ensuring the bearings are fully seated.

  3. Secure with Nuts: Tighten the axle nuts to secure the wheels, allowing for slight wheel movement without excess play.

Step 5: Adjust Truck Tightness
  1. Adjust Kingpin: Use a skate tool to adjust the kingpin nut on each truck. Tighten for more stability (harder to turn) or loosen for more maneuverability (easier to turn).

  2. Personal Preference: There's no one-size-fits-all setting. Adjust the trucks to a tightness that feels comfortable for your riding style.

Step 6: Final Inspection and Adjustments
  1. Check All Components: Ensure all parts are secure and properly adjusted.

  2. Test Ride: Safely test your skateboard on a flat surface to ensure everything feels right. Make any necessary adjustments.
Conclusion
Setting up your skateboard is a rewarding experience that enhances your connection to the board and improves your overall skateboarding experience. By following these steps, you'll not only have a skateboard that's tailored to your preferences but also gain valuable knowledge about maintaining and adjusting your setup as needed.

Now that you're equipped with the knowledge to set up your skateboard, it's time to hit the pavement and enjoy the ride! Remember, skateboarding is about personal expression and fun, so customize your setup to suit your style and keep skating. If you have any questions or need further assistance, our shop is always here to help you with all your skateboarding needs.

Legit since 1987.

Sk8 Skates is more than just a skate and snowboard shop, it is a family of individuals committed to strengthening the Winnipeg skateboard and snowboard scene.

×